3D Systems CUBEX Guía de usuario descargar pdf (Pagina 9)

3. Select to the ‘Home’ option on the main menu.

4. Click the ‘Home’ button. This will move the print jet carriage to each of the home switches, checking the XYZ axis and

the Home function. The print jet carriage should stop in the home position in the back left corner of the machine.

NAVIGATING THE CUBEX MAIN MENU

Navigate the main menu using the arrows on the bottom corners of the touchscreen. (Fig. 16)

LOADING MATERIAL CARTRIDGE

The ‘Replace’ function will take you through the process of removing a cartridge and replacing it with a new one. (Fig. 17) If

you are tting a new cartridge to an empty dock, skip ahead to loading the cartridge.

REMOVING THE CARTRIDGE:

1. Select print Jet 1,2 or 3.

2. A message “Heating Print Jet Please Wait…” will appear on the control panel.

3. Once print jet is heated, gently pull the lament from the feed tube. (Fig. 18)

FITTING THE NEW CARTRIDGE:

1. Remove the thumbscrew from the new cartridge.

2. Install thumbscrew into used cartridge. (Fig. 19)

3. Pull 300mm of material from the new cartridge.

4. Cut 50mm from the end of the lament. (Fig. 20)

5. Thread the lament under the cartridge clamp bar and into the feed tube. (Fig. 21)

6. Install the new cartridge into the cartridge dock. (Fig. 22)

7. Push lament through the feed tube until it begins to jet. (Fig. 23 & 24)

Fig. 16

Fig. 19

Fig. 22 Fig. 23 Fig. 24

Fig. 20 Fig. 21

Fig. 17 Fig. 18

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Sin comentarios

3D Systems CUBEX Guía de usuario Pagina 9