3D Systems CUBEX Guía de usuario descargar pdf (Pagina 17)

Do not change cartridge color or material type during printing; doing so may damage the CubeX.

Please ensure you have followed all CubeX setup instructions before starting a print. Failure to do so may damage

the CubeX.

Test creations have been printed on Your CubeX before leaving our factory. A different material and / or color may have been

used for the test creation and may have a small amount of this test material in the print jet. Therefore, the start of your rst

creation may print some of this material and / or color before it transitions to your material/color of choice.

1. Insert the USB stick containing your .CUBEX le into the USB port on the

CubeX.

2. Use the CubeStick to coat the Print Pad glass with a layer of Cube glue.

PRINTING YOUR FIRST CREATION

WARNING: PRINT TIPS BECOME EXTREMELY HOT DURING SET-UP AND OPERATION. DO NOT TOUCH

PRINT TIP.

PART DENSITY This is how much solid ll your part will contain.

Hollow The part will have no internal structure.

Thin The part will have a small amount of internal structure to give it support.

Medium The part will have a good internal structure supporting it.

Heavy A heavy part with a strong internal structure.

RAFT MATERIAL Use this to select which material will print your raft or the raftless option. We recommend printing raftless

but some larger parts may require a raft.

SUPPORT MATERIAL Use this to select your support material or the no support option. Support material may be required

when printing parts with overhangs greater than 50°. Before printing with supports try rotating your

model in the software to see if this can eliminate the overhangs. If this is not possible then supports may

be required.

SUPPORT TYPE Choose between points and lines for your support material. Does not affect the print if no support is

selected.

FINE DETAIL PRESERVATION Enabling this will preserve ner details of your part, but may affect accuracy.

PART MATERIAL Similar to Printer Conguration, this tells the software which materials are loaded into which print jets.

Part materials works in a similar way to Printer Conguration, telling the software which materials are

loaded into which print jets. Please be sure that the materials selected in part materials correspond to

the print jets the materials are allocated too.

BUILD Once you have selected all of your preferences press the build button to create the .cubex le.

SAVING A .CUBEX FILE FOR PRINTING

1. Click the Save Print File button. (Fig. 58)

2. Choose the location you wish to save the .cubex le, give it a suitable name and click “Save.” Transfer the .cubex le to

your USB stick for printing. (Fig. 59)

Fig. 58 Fig. 59

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Sin comentarios

3D Systems CUBEX Guía de usuario Pagina 17