3D Systems CUBEX Guía de usuario descargar pdf (Pagina 26)

PRINT JET 3 X OFFSET Compare the lines on “X scale 1” and “X scale 3” to nd the ones that most accurately line up. Because

variation is small, it may be easiest to spot 3 that look like they all line up. If this is the case, use the

middle one as the correct one. Mark this line with a pen for easier identication.

On “X scale 3” count from the center line (with the arrow) to the marked line. If you are counting left, the

scale the number is negative. If you are counting right, the scale the number is positive. Write down the

offset.

In the example shown in Figure 33, the X offset for extruder 3 is +1.1mm.

When you have nished inputting your offsets press the function button, the printer will ask you if you

wish to save your settings, use the tick and cross to select yes or no.

3D Systems, Inc.

333 Three D Systems Circle | Rock Hill, SC | 29730

Cubify.com

The 3D Systems logo, CubeX and Cubify are

registered trademarks of 3D Systems, Inc.

1 2 ... 21 22 23 24 25 26

Sin comentarios

3D Systems CUBEX Guía de usuario Pagina 26