3D Systems CUBEX Guía de usuario descargar pdf (Pagina 4)

SAFETY SYMBOLS AND DEFINITIONS

SAFETY GUIDELINES

• Follow all safety rules in this section and observe all cautions and warnings in this guide.

• Do not modify any safety features or make modications to the Cube. Doing so is prohibited and voids warranty.

• Use of print materials, or 3D prints other than 3D Systems print materials and genuine 3D Systems components may void

warranty.

• Adult supervision is required; observe children closely and intervene as necessary to prevent potential safety problems and

ensure the Cube’s appropriate use. Ensure small 3D prints are not accessible to young children.

• These 3D prints are potential choking hazards for young children.

• When the Cube is operating, the print tip on the Print Jet becomes hot; avoid touching this area until it has cooled down.

Hot Surface Hazard: A hot surface is accessible in the vicinity of this sign or at the Print Jet; avoid contact. Hot

surfaces can cause severe burns.

Caution: Indicates something may happen that could cause loss of data, damage to equipment, or could cause

personal injury.

Caution: Indicates a pinch point hazard that could cause person injury.

IMPORTANT SAFETY INFORMATION

The CubeX creates the model by pulling lament from the cartridge through the print jets via the delivery tubes. The lament

is then jetted through the print tip in a thin string of molten plastic. The print jet is accommodated by the print plate, which

lowers incrementally after each layer is deposited so a new layer can be drawn on top of the last, building the part up.

CUBEX 3D PRINTER PROPERTIES

• Plastic Jet Printing technology

• Houses up to three print jets for multi-color and multi-material prints

• Choice between ABS and PLA plastic, both recyclable

• Prints objects up to 275 x 265 x 240 mm (10.75”x10.5”x9.5”)

• EZ load print cartridge

• Fully automated supports: peel off supports for ABS and PLA; PLA supports can also be removed using the Ultrasonic

Support Removal Tank available at Cubify.com/cubex/store_parts

PRINT MATERIALS

The CubeX can use two different types of print materials: PLA and ABS. Each material has unique benets and you can

guide your selection based on the properties your part requires.

CUBEX 3D PRINTER FEATURES AND BENEFITS

1 2 3 4 5 6 7 8 9 ... 25 26

Sin comentarios

3D Systems CUBEX Guía de usuario Pagina 4