3D Systems CUBEX Guía de usuario descargar pdf (Pagina 24)

5. Plug your CubeX into the computer using the PC connection USB port (Fig. 85 & 86). Navigate to the settings tab on

the CubeX software and press the Firmware update button. (Fig. 87)

6. The CubeX software will then open windows explorer. Navigate to the rmware you wish to install and open it. (Fig. 88)

7. The CubeX software will now install the rmware onto the CubeX printer. (Fig. 89)

8. Once the rmware is installed unplug the printer from the mains power for 30 seconds and unplug the USB from the

computer. (Fig. 90) (If you are upgrading from rmware version 1.01 please skip to the section RESTORING THE

SETTINGS TO YOUR CUBEX PRINTER FIRMWARE FROM V1.01)

9. Plug the USB stick into the CubeX printer and turn it on, touch the screen and you will receive a notication of your

settings being restored. (Fig. 91)

10. Your rmware has now been upgraded.

RESTORING THE SETTINGS YOUR CUBEX PRINTER FIRMWARE FROM V1.01

Before following these instructions, please follow instruction 1-8 in the section UPGRADING YOUR CUBEX PRINTER

FIRMWARE.

1. Turn on the CubeX printer. You will see the activation screen.

2. Re-activate your machine using your activation code. (if you do not have your activation code, you can locate it be

going to cubify.com>my account>my devices and then viewing your registered CubeX).

3. Once it is re activated turn off the CubeX printer.

4. Plug the USB stick into the CubeX printer and turn it on, touch the screen and you will receive a notication of your

settings being restored.

5. Your rmware has now been upgraded.

Fig. 78

Fig. 88 Fig. 90 Fig. 91Fig. 89

Fig. 83 Fig. 85 Fig. 86 Fig. 87Fig. 84

Fig. 79 Fig. 80 Fig. 81 Fig. 82

1 2 ... 19 20 21 22 23 24 25 26

Sin comentarios

3D Systems CUBEX Guía de usuario Pagina 24