3D Systems CUBEX Guía de usuario descargar pdf (Pagina 7)

UNPACKING YOUR CUBEX (FOLLOW UNPACKING GUIDE)

1. Open the box and take out the top lid of the CubeX, it’s between two layers of foam. (Fig. 1)

2. With two people take CubeX out of the box, lift from the metal frame on both sides of the machine. Place CubeX on a

table. (Fig. 2)

3. Remove toolkit, power cord, CubeStick and Jet Wiper from bottom of the box. (Fig. 3)

4. Using the nippers supplied in toolkit cut the strap and take out the material boxes. (Fig. 4)

5. Cut away all yellow zip ties holding the Print Jet in place for transport. (Fig. 5)

6. Cut away all yellow zip ties holding the foam parts in place. (Fig. 6)

7. Remove all foam ttings. (Fig. 7)

8. Remove plexiglass Z-Axis guard, by unbolting the 4 screws holding it in place. (Fig. 8)

9. Remove the plexiglass part.

10. Plugging in the CubeX:

• To power on plug the power lead into the power supply located on the base of the machine. (Fig. 9)

• The LED on the control panel should light up indicating your machine has power

• Click the function button on the control panel to turn on CubeX

11. Click the function button to power on your CubeX. (Fig. 10)

12. Using the touch screen navigate to the move function. (Fig. 11)

13. Using the up arrow move the print bed up far enough to remove the foam. (Fig. 12)

14. Remove the last foam piece underneath the build plate. (Fig. 13)

15. Move the Print Pad all the way down to install the Jet Wiper. (Fig. 14)

16. Install the Jet Wiper. Insert the wiper’s two key holes onto the two rods located at the back, right side of printer. The

wiper’s metal piece and spring should be facing the front. (Fig. 4)

Fig. 3

Fig. 4 Fig. 5 Fig. 6

Fig. 1 Fig. 2

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Sin comentarios

3D Systems CUBEX Guía de usuario Pagina 7