3D Systems CUBEX Guía de usuario descargar pdf (Pagina 21)

RESTORING ROUGHNESS TO THE PRINT PAD

To restore roughness to the Print Pad, run the sandpaper included in your toolkit diagonally across the bed corner to corner

in both directions. (Fig. 63)

CUBEX MAINTENANCE

LEVELLING THE JET WIPER HEIGHT

If your Jet Wipe is set too low or too high, you can adjust it using the orange capped bolt located under the print jet, screwing

it into the oor to set the Jet wipe lower and unscrewing it to set the Jet Wipe higher. (Fig. 64)

LEVELING THE PRINT PAD

It is important that the Print Pad is level in order to get a good print. To help you out, we make every effort to ensure that the

Print Pad is level when the machine leaves our factory. However, the Print Pad may move in transit, making it necessary to

check that it is still level when it reaches you.

You will rst need to ensure that your aluminum pad support is level. After this you can install the Print Pad and ne-tune the

leveling.

NOTE: When leveling the Print Pad, always use print tip 1 as your reference.

LEVELING THE ALUMINUM PAD SUPPORT

Before starting the process you need to remove the Print Pad from the aluminum pad support.

The aluminum pad support is mounted on three sprung bolts which allow you to adjust the height of the Print Pad in three

places.

The ‘Level’ function moves the extruder carriage around the corners of the print area so the operator can adjust the Print

Pad support bolts for leveling.

1. Select ‘Level’ on the touchscreen. (Fig. 65)

2. Use the Up and Down arrows to raise and lower the print bed to adjust the gap between the print jet and Print Pad.

Start with approximately 10 mm between the nozzle and the Print Pad. This distance will enable rough leveling. (Fig.

66)

3. Touch the ‘Clockwise’ and ‘Counter-clockwise’ buttons to automatically move the carriage around the corners of the

print area. (Fig. 67 & 68-71)

4. From the side of the machine, observe any changes in distance between the Print Pad and the print jet during each

movement along the side of the Print Pad.

5. Adjust the height of the Print Pad bolts (Fig. 72) to make each side level using the 3mm hex driver from the tool kit.

There is a locking nut beneath each of the 3 bed bolts that must be loosened with the 8mm spanner before the bolt can

be adjusted. (Fig. 73)

6. It may take several extruder movements and bolt adjustments to ensure that the Print Pad is level.

7. Ensure that axes have been checked from the appropriate side of the machine (to better gauge atness).

Fig. 63 Fig. 64

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Sin comentarios

3D Systems CUBEX Guía de usuario Pagina 21